In order to effectively improve the use efficiency of CNC Surface Grinding Machine and prolong the service life of CNC Surface Grinding Machine, it is necessary to pay attention to the following 9 details in the daily use of CNC Surface Grinding Machine:

1. Ensure that the power supply is good and the grounding is reliable;
2. The oil pool should be cleaned after every three or four months of operation, and new filtered oil should be injected; the guide rail surfaces should be kept lubricated and smooth;
3. Regularly remove the protective plates at both ends of the workbench, check the wear condition of the body and the guide rail surface of the workbench; the CNC Surface Grinding Machine manufacturer tells you that if it is in abnormal wear condition, you should readjust the body and the amount of lubricating oil on the workbench. Repair and scrape the guide rail surface;
4. Regularly clean the oil filter screen of the oil pump inlet pipe of the hydraulic system; the coolant pump should be cleaned with water and oil after three or four months of operation;
5. The CNC Surface Grinding Machine manufacturer tells you to regularly clean the coolant tank, the workbench return tank, and the bed drainage tank;
6. CNC Surface Grinding Machine manufacturers tell you that common faults and maintenance can be found in the maintenance table in the instruction manual;
7. The CNC Surface Grinding Machine manufacturer tells you that the machine tool can grind rigid materials, cast iron and non-ferrous metals, and it is forbidden to grind any non-metallic materials;
8. When replacing a new grinding wheel, the allowable linear speed of the grinding wheel is not more than 35m/s, and the taper part of the grinding wheel on which the grinding wheel is installed should be checked regularly, and there shall be no bumps or abnormal phenomena;
9. At the end of the work, the surrounding environment of the CNC Surface Grinding Machine should be cleaned and the surface grinder should be cleaned.