The hmc machining center refers to the machining center where the worktable is parallel to the spindle. Generally, there are three linear motion coordinate axes and one table rotation axis. After the workpiece is clamped once, different tools can be selected independently according to the program, the spindle speed can be actively changed, and the multi-process and multi-face machining can be realized in sequence according to the programming sequence, which is suitable for the machining of box parts. Secondly, introduce the problems that should be paid attention to in the use of hmc machining center.

The hmc machining center should be installed away from the source, away from direct sunlight, without heat radiation and humidity. If there is an earthquake source near the hmc machining center, an anti-vibration trench should be set around the hmc machining center. If there is no anti-vibration groove, it will directly affect the machining accuracy and stability of the hmc machining center. After long-term use, it will affect the poor contact of electronic components, cause problems, and affect the reliability of hmc machining center.
Generally, hmc machining center can only work normally below 30 degrees Celsius. The distribution box of hmc machining center is generally equipped with exhaust fan and air cooler to ensure that the electronic parts and central processing unit work at a constant temperature. If the temperature and humidity are too high, it will lead to a decrease in the life of the control system components, resulting in an unreasonable increase in hmc machining center problems. If the humidity increases, the dust on the integrated circuit board will increase, which directly leads to poor contact and short circuit.
 The hmc machining center is generally installed in the processing workshop. There are many mechanical equipment in the processing workshop, which will inevitably cause turbulence in the power grid. Therefore, the location of the HMC machining center device must strictly control the voltage and current of the power supply. In order to control the power supply voltage and current of the hmc machining center within the allowable range, the power supply voltage and current must be kept stable, otherwise it will directly affect the normal operation of the hmc machining center.
When customers use the hmc machining center, they cannot change the factory parameter settings of the machine tool at will, because these factory parameter settings are directly related to the dynamic characteristics of each part of the hmc machining center, as long as the gap compensation parameter value can be set according to the actual environment. If you want to change the factory parameters, you should contact the manufacturer and change the factory parameters under the guidance of the manufacturer's technicians.