The column type surface grinder manufacturer tells you that the workpiece of the surface grinder is sucked or clamped on the worktable by the rectangular electromagnetic worktable, and reciprocating longitudinally. The grinding wheel carriage can make transverse intermittent feed movement along the dovetail guide rail (machine tool guide rail) of the sliding seat, and the sliding seat can make vertical intermittent feed movement along the guide rail of the column. The workpiece is ground around the grinding wheel with high grinding accuracy.

1. The use of imported precision grinder flanges helps to improve the processing efficiency of the grinder
The column type surface grinder manufacturer tells you that when using a surface grinder for processing operations, the correct use method will help us improve the processing efficiency of the grinder, thereby increasing our production capacity. The column type surface grinder manufacturer tells you that many users who use 350# flanges like to buy the cheaper ones on the market, and the starting point for cost saving is good, but for precision surface grinders, the grinder flanges are still imported. If you use cheaper flanges on the market, it will bring three negative effects:
First, because the poor flange has inaccurate taper and poor concentricity, rotating it on the precision spindle of the grinder will greatly reduce the service life of the spindle;
The second is that the accuracy of the poor flange is not high, and the inaccurate taper will greatly affect the processing effect, and the product defect rate will increase;
Third, due to the low accuracy and poor concentricity, each flange has to go through a balance frame and a balance bar for correction, which wastes a lot of time.
It is recommended to buy #350 flanges before processing or to buy precision imported ones.
2. Tips for the balance correction of the grinding wheel flange of the surface grinder
The column type surface grinder manufacturer tells you that when we use precision grinder flanges for grinding, we don’t need to perform balance correction for each grinding wheel flange. It will take too long. Here is a relatively simple and practical method:
The column type surface grinder manufacturer tells you that when you buy a new precision flange, you only need to remove the three arc-shaped balance correction blocks on the bottom of the flange, install the grinding wheel correctly in turn, and then set the surface grinder spindle grinding head, and use the diamond cutter. After repairing a knife, the grinding wheel flange is naturally balanced. There is no need to spend money to buy a balance frame. The balance bar is used for special calibration. If each grinding wheel flange is calibrated with a balance frame, it will cost more than a dozen. Twenty minutes, but if you remove the balance weight and directly install the grinding wheel, it will be done in two minutes, and the effect is better than the former! This saves at least half an hour every day.
The column type surface grinder manufacturer tells you that the correct use method will not only improve the efficiency of our surface grinder work, but also save us costs and reduce the defect rate of our products.