As a Kent grinder in the machine tool industry, its weight is calculated in tons. Therefore, Kent grinder needs to pay attention to the following related matters during the transportation and installation process.

1. The Kent grinder manufacturer tells you that when moving the machine, you should use a sling or a Ф1/2 steel cable to suspend the lifting bolt, or place the machine on the pallet and use a stacker to carry it. Pay attention to the gravity center of the machine during transportation, and avoid Damage or damage the appearance of the machine.
2. The Kent grinder manufacturer tells you that the installation site needs a solid concrete floor. Other vibration sources (such as punches, roads, etc.) and high-power electrical sources (such as electric spark machines, electric welding machines, etc.) must be avoided nearby to avoid mutual Signal interference, avoid direct sunlight to the machine.
3. When the machine is positioned, it is necessary to use the foot pad and level adjustment foot bolts for level adjustment, and adjust the left and right, front and rear directions to within 0.04/1000 of the level.
4. Kent grinder manufacturer tells you to clean the anti-rust oil part on the machine tool before use.
5. Confirm whether the oil pool at the bottom of the upper frame has been filled with oil, otherwise do not start the lubrication pump.
6. The manufacturer of Kent grinder tells you to confirm the direction of rotation of the grinding wheel on the spindle. It needs to be clockwise to be correct.
7. The Kent grinder manufacturer tells you that when using the disk, the two ends should not be fixed too tightly. To ensure high precision, the magnetic chuck needs to be slightly ground and trimmed after it is installed.
The above are related matters that need to be paid attention to during the handling and installation of Kent grinder, I hope it will be helpful to you!